HOW TO FLASH

------------------------------------------------------------------------------------------------

HOW TO FLASH HUAWEI PHONE WITH SD / OTA UPDATE 

------------------------------------------------------------------------------------------------

INSTALLATION METHOD # 1

1. Connect your phone to a personal computer by using short USB cable. and if your phone is not working properly then you can use SD card reader to copy these required file to the root directory of your sd card.
2. Format your SD card with FAT32 and Make a new folder with the name of “dload” in its root directory.
3. Extract the ZIP file which you have already download from the link above and copy all of its contents (“UPDATE.APP”) to the “dload” folder which we previously created in SD card. 
4. Disconnect your phone from PC or disconnect your card reader from the personal computer.
5. Reboot your mobile into recovery mode by powering off your phone and then holding Volume Down + Volume Up + Power Buttons simultaneously.
6. Within a few seconds of keep pressing these button, the update process will be automatically execute/started. It will take about 3-4 minutes to get it complete, depends on your phone processor and ram speed.
7. When you see the update successfully, you can use the Backup utility to restore all the data you backed up in the beginning.

ANOTHER METHOD TO FLASH THIS FILE

1. Copy the downloaded package to your SD card as I explain it in first method. 
2. Go to your mobile Settings > Updates > System Updates
3. Click on ‘Local Update’, carefully read all the warnings and then make a quick backup of your device (in case you haven’t done that already)
4. Next step is tap ‘Confirm’ to proceed with the update installation. It shouldn’t take more than 10 minutes.

DISCLAIMER:

Please keep in mind mind that despite the fact that, this method has been fully tested and verified, I shall not be held responsible if your device gets screwed up at any point. Apply this update at you own risk.

-----------------------------------------------------------------------------------------------------

INSTALLATION METHOD OF FLASHING SAMSUNG MOBILES

1. After downloading this file extract (unzip) the firmware package. 
2. Download Latest Odin from THIS LINK
3. Extract the downloaded Odin ZIP file on desktop.
4. 3rd step is executing odin software. 
5. Turn your mobile off and remove battery and after few second start your mobile in Download Mode by pressing and holding (Home + Power + Volume Down buttons)
6. After putting your phone in download mode connects phone and wait until odin detect your phone. 
7. Add the downloaded firmware file to AP / PDA field. 
8. Make 100% sure that re-partition option is NOT ticked (Only select when you know what is this option for otherwise you can brick your phone. 
9. When firmware loaded successfully simply click the start button, sit back don't touch any usb or use computer while you are flashing the phone.
10. After few minutes (Depend on your phone memory and ram) you will receive flash successfully message.
11. Your phone will be automatically restart wait until you will see welcome screen on the mobile. 

-----------------------------------------------------------------------------------------------------

HOW TO FLASH SCATTER FILE WITH SP TOOL 

Step 1: Download and extract the firmware on your computer.

Step 2: After extracting you have to download SP Tool if you already have skip this step.

Step 3: Install the USB Driver (Skip if drivers are already installed).

Step 4: Open SP Flash tool and load the Scatter file from the firmware Folder.

Step 5: Click on Upgrade / Download Button in the Sp flash tool to begin the flashing process.

Step 6: Connect your smartphone to the computer using the usb Driver.

Step 7: Green Ring will appear at the end of successful Flash.

DISCLAIMER: 


Please keep in mind mind that despite the fact that, this method has been fully tested and verified, I shall not be held responsible if your device gets screwed up at any point. Apply this update at you own risk.