HUAWEI MEDIAPAD T1 SERIES IS ONE OF THE BEST MODEL OF HUAWEI BRAND. THIS MEDIA PAD HAVE SPD 8830. THIS TAB HAVE DIFFERENT VARIANT / COUNTRY. HERE IN THIS THREAD WE ARE PROVIDING ALL THE POSSIBLE VERSION OF THIS TAB. OFTEN THIS TAB ENDS UP MANUAL UPDATE FAILED JUST BECAUSE OF PEOPLE DON'T PAY ATTENTION TO ITS VERSION / BUILD / COUNTRY. THAT'S WHY I HAVE HIGHLIGHTED VERSION BUILD AND COUNTRY CODE WITH RED. PLEASE CHOOSE IT WISELY AND FLASH IT BY SD CARD OR BY CODE AT THE END I WILL GIVE YOU FEW TIPS TO DOWNLOAD FIRMWARE. HOPE THAT WILL HELPS YOU A LOT.
|
Filesize: 853.27 MB
|
|
|
Filesize: 569.32 MB
|
|
|
Filesize: 1.52 GB
|
|
|
Filesize: 762.82 MB
|
|
|
Filesize: 850.96 MB
|
|
|
Filesize: 850.96 MB
|
|
|
Filesize: 734.34 MB
|
|
|
Filesize: 1.02 GB
|
|
|
Filesize: 1.02 GB
|
|
Filesize: 514.57 MB
|
INSTALLATION
METHOD # 1
1.
Connect your phone to a
personal computer by using short USB cable. and if your phone is not working
properly then you can use SD card reader to copy these required file to the
root directory of your sd card.
2.
Format your SD card with
FAT32 and Make a new folder with the name of “dload” in its root directory.
3.
Extract the ZIP file which
you have already download from the link above and copy all of its contents
(“UPDATE.APP”) to the “dload” folder which we previously created in SD
card.
4.
Disconnect your phone from
PC or disconnect your card reader from the personal computer.
5.
Reboot your mobile into
recovery mode by powering off your phone and then holding Volume Down + Volume
Up + Power Buttons simultaneously.
6.
Within a few seconds of
keep pressing these button, the update process will be automatically
execute/started. It will take about 3-4 minutes to get it complete, depends on
your phone processor and ram speed.
7.
When you see the update
successfully, you can use the Backup utility to restore all the data you backed
up in the beginning.
ANOTHER
METHOD TO FLASH THIS FILE
1.
Copy the downloaded package
to your SD card as I explain it in first method.
2.
Go to your mobile Settings
> Updates > System Updates
3.
Click on ‘Local Update’,
carefully read all the warnings and then make a quick backup of your device (in
case you haven’t done that already)
4.
Next step is tap ‘Confirm’
to proceed with the update installation. It shouldn’t take more than 10
minutes.
DISCLAIMER:
Please keep in mind mind that despite the fact that,
this method has been fully tested and verified, I shall not be held responsible
if your device gets screwed up at any point. Apply this update at you own risk.
Post a Comment